When you want to install a car lift, you should have a concrete foundation ready. The concrete should be at a certain depth. If you are not sure how to do it, you can contact a professiona Mechanic Superstore's to help you. An experienced installer can help you get the lift installed and troubleshoot any problems that might arise.

Adding micropiles

In addition to the usual reinforcement, micropiles are a more cost-effective option than bedrock or shallow bedrock. As a result, micropiles provide an attractive alternative to the conventional foundation system that is subject to uplifting forces caused by groundwater.

Micropiles are installed using gravity or pressure grouting. Pressure grouting uses a geotextile or rubber packer that is inflated by air and then fixed to a reinforcing bar using wires. Once the grouting has cured, the geotextile packer is removed and reused.

Adding gravel

When adding a 2 post car lift, it's essential that the ground under the car lift is level. If the ground is not level, you should add a layer of gravel or stone before pouring the concrete. This will prevent the ground underneath from shifting. It is important to use the right amount of gravel or stone.

The gravel should be placed a minimum of 2 inches below the car lift's surface. You can use a carpenter's level to check the level of the gravel. You can also use a plate compactor to compact the gravel. Make sure that you run the compactor from side to side, as well as from north to south.

Pouring concrete at a certain depth

The thickness of concrete that needs to be poured for a car lift floor will vary depending on the lift type. The manufacturer 2 post car lift will usually have a recommendation on what the proper thickness is. Once you've found the thickness you need, you'll need to cut a pad into the floor where you're going to place the car lift. You'll then need to pour the concrete into the pad to meet the specified depth.

In addition to using a proper concrete mix, you should also include gravel under the concrete. This will ensure that the concrete is level and doesn't sink too far. Skipping this step may lead to uneven concrete, which could damage the 2 post car lift

Adding a finish coat

Adding a finish coat to concrete is crucial if you want your car lift to last. It prevents cracking of the concrete slab. It is also helpful to add four inches of gravel or stone to the garage floor before pouring the concrete. This way, you can prevent the ground from moving around while the concrete is hardening.

Allowing concrete to cure

Before installing a car lift, it is essential to allow concrete to cure properly. It is important to control the temperature and moisture content of the concrete, which will increase its structural integrity and resistance to cracking. To prevent cracks from developing, the following best practices should be followed: a. Wait at least a week to allow the concrete to fully cure before using it.

The time required for the concrete to fully cure is largely dependent on the concrete's design and curing process. For example, some concretes reach their minimum strength within seven days, while others can take up to 28 days.